Mylex PCI to Ultra 160 SCSI RAID Controller AcceleRAID 170 Przewodnik Instalacji Pobierz pdf (Strona 34)

Installation Process

2-14 AcceleRAID 170 Installation Guide

Setting SCSI Device IDs

4. Set the SCSI ID on the disk drives; ID 7 is reserved for the controller.

See Figure 2-12.

☛ Note

Each drive must have a unique ID chosen from

0 through 6 or 8 through 15. Be careful not to

duplicate a drive address.

Remember: ID 7 is reserved for the controller;

therefore, it cannot be used as a disk drive ID.

ID’s from 0 through 6 are usually for Narrow,

8-bit devices. However, the full range of SCSI ID

addresses, 0 through 6 and 8 through 15 can be

used for Wide, 16-bit devices.

See your device documentation for instructions on

how to set your particular disk drive’s SCSI address.

Figure 2-12. SCSI ID Numbers

SCSI ID Numbers

7 is reserved for the controller

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 81 82

Brak uwag

Mylex PCI to Ultra 160 SCSI RAID Controller AcceleRAID 170 Przewodnik Instalacji Strona 34