Mylex DAC960PG Przewodnik Instalacji Pobierz pdf (Strona 84)

Installation

B-6 DAC960PG Installation Guide

3. Remove the protective pin cover and peel-off label from J1 on the

IBBU.

4. Leaving the 4 standoffs attached to the IBBU, remove a nylon screw

from the free end of each nylon standoff.

Figure B-3. Installing the IBBU onto the DAC960PG

5. Install the IBBU so that J1 on the IBBU connects to J5 on the

DAC960PG. Pin 1 on the IBBU’s J1 must connect to hole 1 on the

DAC960PG’s J5. The mounting holes on the IBBU will line up with

the mounting holes on the DAC960PG if the connectors are plugged in

correctly.

6. Be sure the 4 standoffs line up with the 4 holes in the DAC960PG.

Place a nylon screw through a hole from the back of the DAC960PG

into a standoff, and turn the screw to the right until it is snug (not too

tight). Repeat this step with the remaining 3 standoff screws.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 105 106

Brak uwag

Mylex DAC960PG Przewodnik Instalacji Strona 84